Components

              - HEATING ELEMENTS

• Standard types for single or double cross flow blowers with length 180 or 270 mm.  Different lengths on request
• Self resetting safety thermal protector
• Electric connection by means of 200 mm long cables
• Half power or full power operation selected by proper electric connection
• Provision for screw fastening to the air outlet of the cross flow blower
• Negligible obstruction to the air stream
• Dissipated power can be chosen in the range 300 to 2000 watt.

             - SPEED REGULATORS

• Phase control type for resistive or inductive loads. Current up to 1,5 A rms and voltage up to 240 V. Higher load types on request
• On/Off switching at start of potentiometer shaft clockwise travel. 
• Simple series connection to the load.
• EMC standards compliant
• Minimum speed manual adjustable according to the load 
• Can be connected to any type of Trial ac blower or fan.

             - BRACKETS

• Designed as fastening units for the Trial axial fans
• Protected against corrosion

             - WHEELS

• Designed for the Trial 4 pole motor axial ventilators
• Two types available, according to the direction of the air stream, towards or from the motor.

 

• “The products listed in this catalogue are intended as components  for factory installation in end-products or equipment rather than for field installation. Although these products comply with the safety standards for components, the final performance is to be checked in the end-product. The performance check of a production pre-series lot is suggested.

• “Limitation of Liability.  Trial will not be responsible for damages or losses of profits incurred by customers consequential to improper use  in the end-products.”

	Please note: you must be a registered user if you wish to see the attachments. In case you have already registered your username and password, please click here.